Maintenance of equipment during holidays|| CNC Nesting machine

Maintenance of equipment during holidays|| CNC Nesting machine

1、Make a backup of the controller software, and put the compressed package in a U disk or computer.

2、After cleaning the external dust and impurities of the machine table, table top, drag chain, screw, rack and guide rail with gas, brush the rack and guide rail with lubricating oil (use machine tool guide rail oil ISO VG-32~68 machine oil, no butter) to ensure that there is oil on the guide rail and rack of each shaft, and drain the water from the oil-water separator in the bed.

3、Clean the impurities on the surface of the drilling package with gas. The CNC drilling gear box needs to be filled with lubricating oil from the oil filler: 5cm, Krupp L32N lubricating oil.

4、Cut off the power supply of the distribution box, and clean the dust in the distribution cabinet with vacuum (Note: don't blow directly with gas, raising dust will lead to poor contact of electronic components). After cleaning, place desiccant in the cabinet.

Clean and maintain the periphery of the spindle and handle with gas; Clean the taper hole surface at the joint with a soft and clean rag. Clean and maintain the taper surface of the handle carefully with degreaser, and apply lubricant after cleaning.Remove the filter element of the vacuum pump and clean it with soot blowing. Check the height of graphite sheet once, the VTLF250,360 shall not be less than 41mm, and the VTLF500 shall not be less than 60mm. Add Krupp AMBLYGON TA-15/2 lubricating grease, 10ml.